Thingiverse
Mosquito net holder
di 4eDo
1
Download
1
Likes
0
Makes
Holder for mosquito net.
The original holders died, these were created based on their remains.
The upper ones are 2 mm longer than the lower ones.
Thickness 2.5 mm
For printing, place on the end.
Without supports.
Filling 100%
1 perimeter, so that there is no empty space between the lines inside.
I needed it urgently, so the plastic is PLA. But ABS is still better for the street, especially if you need dark mounts. But there are no special loads here, and you can always reprint.
The original holders died, these were created based on their remains.
The upper ones are 2 mm longer than the lower ones.
Thickness 2.5 mm
For printing, place on the end.
Without supports.
Filling 100%
1 perimeter, so that there is no empty space between the lines inside.
I needed it urgently, so the plastic is PLA. But ABS is still better for the street, especially if you need dark mounts. But there are no special loads here, and you can always reprint.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
