MakerWorld
Other Tools
Go to Model
Mostly Printed CNC -Add On- End Stop Mount
23
Downloads
5
Likes
9
Makes
Min and max end stop mount for, all three versions of theMPCNChttps://www.v1engineering.com/Easily change your home position, stop working in the same corner. Position your material where ever you want.I printed these in PLA and they have to flex a lot to get over the rails but they seem fine after repeated tests.If you have followed this project you probably know I am against end stops. Maximums can be very useful for when you mess up your gcode, the machine will stop if it goes too far. This works on all axis for a minimum or maximum position indicators. The ramps board will accept all 6 at once.Wire it in the NO position and no firmware changes will be needed for the MPCNC.
V1 Engineering also publishes on
96 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!