Thingiverse
Moto 360 Loader-Holder
von UltiLolle
5
Downloads
10
Likes
0
Makes
Cable holder for Moto 360 2nd Gen.
Cable, plug, charge all together at a socket!
(Whether it fits for the big version of the clock I can not say ... but it should actually)
The cable of the plug is rolled up and stowed in the holder. The end of the cable is led outwards on the back of the holder and inserted into the charging tray. The cable can be fixed in the 3mm slot on the back of the holder for a clean fit of the charging tray.
If the cable is rolled up neatly and stored in the holder, you can plug the entire charging unit as one part free of wipes into a socket and charge your smartwatch.
Easy to print upright.
Chears Lolle
Cable, plug, charge all together at a socket!
(Whether it fits for the big version of the clock I can not say ... but it should actually)
The cable of the plug is rolled up and stowed in the holder. The end of the cable is led outwards on the back of the holder and inserted into the charging tray. The cable can be fixed in the 3mm slot on the back of the holder for a clean fit of the charging tray.
If the cable is rolled up neatly and stored in the holder, you can plug the entire charging unit as one part free of wipes into a socket and charge your smartwatch.
Easy to print upright.
Chears Lolle
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
