Motor Controller Case - HiTec

This is a slightly modified version of the HiTec Motor Controller case. Having had the screw holes and tabs get broken many times over the years, thought this would be handy to be able to replicate and replace the bottom half of the case. I've made a slight tweak so that the holes on the tabs are a bit smaller to work better with the 6-32 screws usually used to attach them. I invite folks to take the STEP file and do some remixing to innovate on new and better ways to connect these to robot chassis. Even though they're legacy, i'm betting there are still a lot of FTC teams still using them out there.

The top is split into two files because it made printing it a lot easier and i didn't see any real problem with doing it that way. Tried printing the top as one piece with supports and it didn't work well, but feel free if you so choose.