Motorcycle Flat Mirror Mount

I made these to mount the generic bar end mirrors you can find all over ebay/amazon/aliexpress/etc. to a horizontal position. The base mount will work with the stock arm and cap. It requires an M5 nut to be put in the back..

I also made a replacement for the arm and the cap if you want it all to be in one.. However, do not put to much pressure on the cap with a bolt.. it will crack if you tighten it to much.

Recommend printing the mount with the hole for the nut facing up.. Otherwise the angled supports on the back will print nasty.

Recommend printing the cap standing straight up for layer support.

I printed the arm flat with the threaded side facing up and that seemed to work well.