Thingiverse
Motorguide Rack Guide
von gerhardbooysen
1
Downloads
0
Likes
0
Makes
I needed replacement parts for my bow mount Motorguide 75LB 24volt sneaker motor.
Getting the parts to my country is expensive so I thought it good to print one and improve on the design.
I printed these with PLA+ at .25 layers with 35% infill.
Getting the parts to my country is expensive so I thought it good to print one and improve on the design.
I printed these with PLA+ at .25 layers with 35% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!