Motorized High Bypass Engine

Includes parts to adapt it to the standard and remixed High Bypass Jet Engine. Also fits the High Bypass engine Nacelle. This motor system is completely self-contained within the nozzle cone (plug). A push-on/push-off button is located at the tip of the nozzle. It runs on 8 AAA cells at 72 RPM. Full load measured 120 mA. This should give about 8 hours of run time from good quality batteries. The bearings should be cleaned of all grease and relubricated with light oil. The engine model must spin freely. While this motor has significant torque, tight spots and sluggish bearings will greatly diminish battery life and could prematurely wear out the gear-motor.The Molex connectors can be substituted with just about any type and brand. I used these because I had a lot on hand. The wiring can be run direct without connectors if desired. This electric motor arrangement will not work with the original 3D Printable Jet Engine by Chris Shakil unless my remixed nozzle, mixer, and nozzle stator fil