Slicer Discord
Motorized Strandbeest Remix – 3D-Druckmodell von Thingiverse Thingiverse

Motorized Strandbeest Remix

von Dbakardj
23 Downloads
15 Likes
0 Makes
Zum Modell
Not sure I'm the first to motorize this, but here is my take on it. I used some salvaged ink jet 12 volt DC motors. I realize I am not using the full potential of speed with a 9 volt battery running in parallel, but don't feel like adding another battery and involving a resistor. I uploaded the bracket more for demonstration. If you attempt this project, you'll most likely have to make your own version (unless you can find the exact width sized motors.). I ran both DC motors in opposite directions so the Strandbeest could move in one direction. I did try this version with one motor, but it was too heavy on one side and would not turn. Adding 2 nearly identical motors, one to each side, distributes the weight and provides more than enough force to get this thing running on land autonomously.

I tried to take as many photos from as many positions as I could so you could see how I made this, but if it's not enough, fell free to leave a comment or note.

If you want to see it in acti
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen