Motorized turntable

3D Printable motorized turntable.

Check out the full build video here: https://youtu.be/OTC3A-28yWQ

**IMPORTANT: Make sure to buy a motor rated for the correct voltage based on where you live.** You can get the motor here: https://amzn.to/421AvTn

**Parts required for this build:** (Affiliate links)
3D Printer Filament: https://amzn.to/3JbtZ3N
Skateboard bearings (608): https://amzn.to/3Le8C4o
Cable with switch: https://amzn.to/3ZHKz1Y
M3 Screws and nuts: https://amzn.to/3LhyLz6
If you don't have a 3D printer, you can buy that here as well!
https://amzn.to/3Jw22nx

**FOR YOUR OWN SAFETY: Be careful not to touch the power connectors while the cable is plugged into the wall, make sure to isolate them properly with heat shrink or electrical tape, and DO NOT plug in the power cable until the project is fully assembled.**