Motorized USB Yarn Winder - Electronics Case

IMPORTANT NOTE: This is an attachment for the following model: https://makerworld.com/en/models/1212875-motorized-usb-yarn-winder#profileId-1228102 BOMGet the BOM of the original item without the optional motor controller, and then add the following: QtyNameUrl1Motor Speed Controllerhttps://amzn.to/426ceMF 2M3x30 SHCShttps://amzn.to/3QV1xaB Assembly: Step 1: Wire ElectronicsCut the wire to the motor, leaving 2-3 inches. Strip off the outer wire casing for 2-3 inches on both sides of the cut you just made. The motor side should now have zero outer casing.Strip 3mm of the 4 wires you now haveAttach the wires to the Motor Speed Controller terminals. Test that everything is working by plugging in the USB and making sure the motor spins and that the dial speeds it up and slows it down.Step 2: Install Electronics - Motor Speed ControllerPut the Motor Speed Controller into the Electronics case, making sure the terminals face up. Put on the washer and the nut and tighten until it's very sn