mount and trigger for optical limit switch

I have a Prusa 2 with a z limit switch. every time the machine touches the switch it gets bumped a little bit out of alignment. I needed a switch that never got touched so it would stay where I put it.

[Get the same switch here](https://www.marginallyclever.com/product/touchless-3d-printer-endstop/) **no longer available**

[See calibration here](https://www.youtube.com/watch?v=KpP7NQRpU3A)

Bonus I didn't realize early on: when very very close to correctly tuned the LED on the switch fades in and out as the trigger only partially blocks the optical sensor. You can watch the brightness while fine tuning to get better results.

Designed in Fusion360.

Support me through Patreon: https://www.patreon.com/imakerobots

Or make a one time donation: https://www.paypal.me/imakerobots
Every like, share, and subscribe helps!

Blog: http://marginallyclever.com/
Instagram: https://www.instagram.com/imakerobots
Facebook: https://www.facebook.com/MarginallyClever
Twitter: https