Thingiverse
Mount for Aqara Zigbee Door Open Sensor
door DavidPhillipOster
1
Downloads
1
Likes
0
Makes
I put the sensor in a mounting bracket so I can change its battery in a few years.
The bracket and magnet are attached with double-faced foam tape.
My windows have a handle that protrudes into the room, so I can't reach the handle to close it with the window screen in place. So, I put the magnet on the screen - the sensor reads "closed" when the screen is in place, and "open" when I've removed the screen to close the window.
Because of the overhangs on the sensor bracket, I print it vertically with bottom supports.
I connected the Zigbee sensor to Home Assistant, and set up a pair of automations: When I put the screen in the window, set the HVAC system to off. When I take the screen out of the window, restore the HVAC system to heating or cooling if needed.
Simple, and I don't have to worry about paying to run the HVAC while the window is open.
The bracket and magnet are attached with double-faced foam tape.
My windows have a handle that protrudes into the room, so I can't reach the handle to close it with the window screen in place. So, I put the magnet on the screen - the sensor reads "closed" when the screen is in place, and "open" when I've removed the screen to close the window.
Because of the overhangs on the sensor bracket, I print it vertically with bottom supports.
I connected the Zigbee sensor to Home Assistant, and set up a pair of automations: When I put the screen in the window, set the HVAC system to off. When I take the screen out of the window, restore the HVAC system to heating or cooling if needed.
Simple, and I don't have to worry about paying to run the HVAC while the window is open.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
