Mount for Full Graphic LCD Controller

January 22

I wanted a simple mount to attach a new [RepRap Discount Full Graphic Smart Controller](http://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller) to my FolgerTech printer. This is certainly not a case for the electronics. At some point I'll get around to enclosing the electronics and cleaning up the wiring, but that's a project for another day.

The corners of the controller board are squeezed by the four bosses on the mount. I printed these without support and did a little filing to open up the groove for each corner. This mount is attached to the RAMPS / Arduino mounting panel with two M3 screws.

Here is the design in [OnShape](https://cad.onshape.com/documents/5887ba9e08dba31063554632/w/3911a9fd9989e50d3e275fad/e/768c610c0cb62540fe973f95).

This is for Pittsburgh's [Fun a Day, 2017](http://funadaypgh.blogspot.com).