Mount insert for Beeline Velo 2

A 1/8 turn mount insert for a Beeline Velo 2, that replaces a garmin quarter-turn style mount insert. Designed for mounts with a 22mm spacing between the mounting bolt holes, such as the [TOWILD ALB05](https://www.amazon.co.uk/dp/B0BDDYYKWR?ref=ppx_yo2ov_dt_b_fed_asin_title) handlebar mount.

Printed using PETG and tested successfully on my own bike. Came up with this because the official insert adaptor that beeline sells doesn't have a wide enough hole spacing for some mounts - such as the TOWILD one mentioned above.

Because the screw holes are so close to the edge, it is a little bit of a squeeze to get the screw heads past the locking tabs on the rim, but it can be done. I recommend getting the screws into the holes before trying to line it up with the mount bracket.

Print settings (used on a Creality Ender 3 v2):
* PETG filament
* Layer height: 0.12mm
* Infill density: 100%
* Supports: partial - only underneath the central section, not under the 4 corner tabs round the inside edg