Mount replacement for Insta360 One X

This is made to be printed with TPU, with 15 walls and 100% infill. If you print it with anything other than TPU, then the screw hole will probably be too small to screw in. TPU compresses so the screw hole needed to be a bit tighter. Print it with TPU so that it won't break.

I made this remix because I broke the mount on my Insta360 One X, which meant that I could no longer mount it anywhere.
I use it in aerial sports so I can't just mount it with the little screws at the bottom or trust my camera on a PLA case print. I found this to be a mount that I can trust fully.

This was designed to be mounted to the camera using tape. It doesn't block the battery compartment, nor the sd card, but it does block the micro usb port so keep that in mind. If you don't have an external charger, maybe go get one first. This mount was designed so that you install it one time and it stays there. You can't just take it off every time as you have to take off all the tape and re-install it afterwards.