Mountain Dew Zero Sugar Lightbox

This lightbox is 30 cm x 14 cm x 3 cm at its full scale. It prints in two halves that can be easily snapped together without glue or hardware. There is no hole in the back for a LED cord to be connected through, but if you want one, you can add a side hole in your slicer if that is preferred. Filaments Used:Light Green: Bambu Lab Mint Lime (Gradient)White: Bambu Lab Matte Ivory WhiteRed: Bambu Lab RedDark Green: eSun PLA+ Pine GreenIf you need a LED light strip to use with the lightbox, I highly suggest these Neon Rope Lights - 3.2ft RGB LED Strip with App Control from Amazon NOTE: This logo is not licensed and therefore cannot be used commercially. For the best results, I highly recommend doing the following:Clean your build plate thoroughly before starting to get the best adhesionUse a very slow print speed on the first layer, again for good adhesion (something like 15-20mm/s)Let the print fully cool before trying to remove either half from the print bed to avoid warpingThis lightbox