Thingiverse
Mountain Theme Light Switch Cover
door jethawk
1
Downloads
0
Likes
0
Makes
Converted a dxf image over to CAD, extruded certain layers, printed in all white, and then painted each layer a different color and viola! Took awhile to paint it, but I think it was worth it and I enjoy being somewhat creative.
My ender 3 V2 has a 235x235mm build plate and I had to rotate the part 45° to get it to fit on the build plate. I assume most others will need to do something similar.
2 notes from when I made this:
- Make sure your bed is flat. Any warping or improper adhesion will cause the plate to not sit flush against the wall.
- Because I had a little elephants foot with this print I needed to use an exacto knife to trim the backside edges for the light switch. All that to say careful on your first layer settings.
My ender 3 V2 has a 235x235mm build plate and I had to rotate the part 45° to get it to fit on the build plate. I assume most others will need to do something similar.
2 notes from when I made this:
- Make sure your bed is flat. Any warping or improper adhesion will cause the plate to not sit flush against the wall.
- Because I had a little elephants foot with this print I needed to use an exacto knife to trim the backside edges for the light switch. All that to say careful on your first layer settings.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!