MakerWorld
Other House Models
Go to Model
Mounted Cupholder
7
Downloads
1
Likes
3
Makes
Cupholder that was requested for my friend's wheelchair. It has a 1.5-inch diameter mount for clipping onto the side with slots for zip ties to increase stability. There are drainage holes at the bottom.Made to fit refillable water bottles so to fit smaller items like cans it can either be scaled down or add a foam insert to reduce rattling. Adding a foam insert will also help with insulation but be aware that it might block the drainage holes. Print DirectionsLayer Height: 0.3mm at least, use as large as possible to speed up printsInfill: 15% - 25%Supports: Recommended touching build plate onlyMaterial: PLA, Recommended ABS or PETG if outdoors
Steve also publishes on
333 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!