Slicer Discord
Mounting Base Scottoiler eSystem – 3D-printbaar model van Thingiverse Thingiverse

Mounting Base Scottoiler eSystem

door Harry_D60
17 Downloads
30 Likes
0 Makes
Model downloaden
I am a fond user of the Scottoiler eSystem, an automated system to lubricate your motorcycle's chain & sprockets.

However, mine was installed on the left handlebar, using the standard mounting bracket. This works good normally, but alas - not in combination with my tank bag! In tight turns, when moving the bike about, the display unit often hit into the bag... Not the best base for a long product life, I thought...

So I figured, I'd try to think of an alternative mounting assembly & here's my take. :-)

The platform (for the display) and the clamps for the handlebar were easily done - for the swivel, I needed a few iterations to find the one that (I think) will suit my bike best.

- 1) This design is intended for a Suzuki V-Strom: other bikes may have different handlebar diameters.
- 2) The handlebar clamp #2 is fitted with a thin neoprene rubber sheet, to increase friction on the handlebar.
- 3) Tolerances are targetted at my printer & settings - adjust as required.
-
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

3 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie