Mounting Wedges

Mounting Wedges:
- **For work such as laying floors and for other applications...**

- Self-Locking: Works with each other when used in pairs, but the wedge will also work well alone.

- Bended: Works as a compression spring and secures the wedge in position (For example if you work near the wedges with a hammer and cause vibrations, the straight ones will loosen without pressure). I tested the straight ones and didn't have good results as the bended.

- Dimensions: Width: 35 mm, Lenth: 59 mm, Height: 6 mm
Maximum spread in a pair: 10mm

**Print Settings:** 🖨⚙

- **Filament material:** PLA, PETG
- **Layer height:** 0.3
- **Infill:** 30%
- **Print speed:** Up to 30mm/s (Keep low, for good printing of small teeth)
- **Print Orientation:** As it is in STL files
- **Supports:** NO



Mounting Pads:
- **Height of pads:** 1, 2, 3, 4 and 5 mm
- For precise height, print pads with **layer height: 0.25mm**