Thingiverse
Mouse Bungee
door Pixelcloud
85
Downloads
83
Likes
1
Makes
Hello !
This is Mouse Bungee for better cable management. Cable mount should work for 2.5-4mm cable thickness. To add some weight, drill holes at the bottom and apply some plaster/concrete. Add rubber/silicone feets to prevent sliding on the table. Print without supports.
You need Springs with this parametes:
Length: 60mm
Out diameter: 3mm
Inner diameter: 1.9mm
Wire diameter: 0.5mm
You can order them on chinese website with 0.70$ per 5.(I don't get anything by posting link to shop):
http://bit.ly/2ResFot
You can fallow me on:
Facebook
Artstation
Youtube
Check out my models on:
CGTrader
Unity asset store
Turbosquid
Cubebrush
Unreal Engine marketplace
This is Mouse Bungee for better cable management. Cable mount should work for 2.5-4mm cable thickness. To add some weight, drill holes at the bottom and apply some plaster/concrete. Add rubber/silicone feets to prevent sliding on the table. Print without supports.
You need Springs with this parametes:
Length: 60mm
Out diameter: 3mm
Inner diameter: 1.9mm
Wire diameter: 0.5mm
You can order them on chinese website with 0.70$ per 5.(I don't get anything by posting link to shop):
http://bit.ly/2ResFot
You can fallow me on:
Artstation
Youtube
Check out my models on:
CGTrader
Unity asset store
Turbosquid
Cubebrush
Unreal Engine marketplace
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
