Thingiverse
MOUSE FIGURE
by catf
78
Downloads
88
Likes
0
Makes
I present to you different mouse figurines for decorated your interior, ideal for a child room 8 in all
All figures are small sizes 4 cm long 2 to 3 cm wide and 1.6 mm deep
The support has been printed in PLA, and painted with acrylic paint then I varnished them with an aerosol all supports fast drying (inside / outside) for a better holding of the paint
50% Sufficient filling rate if painted thereafter
70% print speed not too fast for better rendering
215 ° PLA printing temperature
60 ° shelf temperature
0.2 layer thickness
0.8 hull thickness
NO SUPPORT
PRINTING TIME 37 MIN
All figures are small sizes 4 cm long 2 to 3 cm wide and 1.6 mm deep
The support has been printed in PLA, and painted with acrylic paint then I varnished them with an aerosol all supports fast drying (inside / outside) for a better holding of the paint
50% Sufficient filling rate if painted thereafter
70% print speed not too fast for better rendering
215 ° PLA printing temperature
60 ° shelf temperature
0.2 layer thickness
0.8 hull thickness
NO SUPPORT
PRINTING TIME 37 MIN
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!