Mouth Piece

This is a Mouth Piece for the Deadrabbit RDA.
Might need some light sanding where it slides in with the O-ring.
Probably want to print upside down as to not use supports.

Also, if the plastic gets too hot in might smush as it prints so maybe try on a lower temperature, I don't know you know your printer.

Takes a little less than 35 minutes to print.


Edit: Some reason the STL came out on its side. oof.

Edit2: Got time to print today, and I printed on 50% infill and .06 layer height.
The mouthpiece came out slightly elliptic, weak and slightly too small. I am going to print on 100% infill, .15 layer height and slower on my printer, takes about 15 minutes. Update soon.