Mowrator controller thumb stick modification

This is a system for adding extra leverage to your Mowrator controller.It's designed around an adapter that clamps over the sticks on of the controller, and then various pads which can mount on top of the adapter.Printing and Assembly:The adapter pieces must be printed upside down (the larger side down). You must add a pause at the correct layer to drop in a standard M3 nut on the adapter. This is the embedded nut for installing the top plates.See Photos:Assemble the "right" and "left" components over the stick as shown. Be careful not to squeeze in any extra silicon from the Mowrator controller.Hold them firmly together over the stick and use 2x M2 screws/nuts to assemble. (see photos)The pads are keyed to fit on top of the adapter. They may be relatively tight, work them onto the adapter. Secure with a M3 bolt into the embedded M3 nut.