Moza SRP Clutch Spring Performance Kit

3D Printed Performance kit I designed for the Moza SRP Clutch that enables you to use the springs from the Moza SRP Accessory Kit for your clutch without needing to buy the SRP Lite Performance kit, giving you a better feel when using the clutch. Should also work for the SRP lite but haven't tested it. Also Requires:A Nail with a flat head and tip blunted, between 75 - 83mm in length and ~3.2mm in diameter. This is used as the alignment shaft that is inserted through the back of the top block and runs though the springs, spacer and bottom block. A Bolt at least 49mm, along with nut and washers. This is used to secure the top block to the pedal arm using the existing holes and also holds the nail in place.Some silicone grease to lubricate the nail.Printed in PLA with 4 Wall loops and 15% Gyroid infill. Seems to be strong enough.