Thingiverse
MP-40 Face Guard
von inventmarine
2
Downloads
2
Likes
0
Makes
Face guard for Ecotech Vortech MP-40 aquarium wavemakers.
The original propeller guard has thin walls with the tendency to break and once they break, the propeller starts to rub on the walls of the cage and with time the wet-side needs to be replaced.
This part be used to replace the broken plastic and prevent propeller damage. Remove the original face guard with a sharp tool and use superglue to attach it to the original cage.
Use 100% infill.
PETG is recommended.
https://youtube.com/shorts/c_EvLOzCPK4?feature=share
Print time is ~36 minutes.
The original propeller guard has thin walls with the tendency to break and once they break, the propeller starts to rub on the walls of the cage and with time the wet-side needs to be replaced.
This part be used to replace the broken plastic and prevent propeller damage. Remove the original face guard with a sharp tool and use superglue to attach it to the original cage.
Use 100% infill.
PETG is recommended.
https://youtube.com/shorts/c_EvLOzCPK4?feature=share
Print time is ~36 minutes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
