Thingiverse
MP Mini Dial Indicator Mount Neoteck
door K2nice
3
Downloads
3
Likes
0
Makes
Use to level the bed for MP select mini. This mount is for Neoteck indicator (https://www.amazon.com/gp/product/B01JYCVHLK/ref=od_aui_detailpages00?ie=UTF8&psc=1). These are the steps I used to level the bed (use figure below as a guide)
1) Put the extruder to home position (corner 1). Use a piece of paper to calibrate this corner.
2) Raise the extruder to about 2 inch in Z direction. Then move the extruder to the middle of the bed in x direction.
3) Mount the indicator at the calibrated corner 1 and zeros the indicator.
4) Move the bed in Y direction to corner 2. Calibrated this corner,
5) Remove the indicator and mount it to corner 3 position. There is some slack in the mount. Therefore try to keep it consistent with how you mount it at corner 1. This will take some practice to get used to. Now calibrated corner 3
6) Move the bed in Y direction to calibrate corner 4.
7) Remove the indicator and home the extruder. Check again with a piece of paper to be sure.
Figure:
1) Put the extruder to home position (corner 1). Use a piece of paper to calibrate this corner.
2) Raise the extruder to about 2 inch in Z direction. Then move the extruder to the middle of the bed in x direction.
3) Mount the indicator at the calibrated corner 1 and zeros the indicator.
4) Move the bed in Y direction to corner 2. Calibrated this corner,
5) Remove the indicator and mount it to corner 3 position. There is some slack in the mount. Therefore try to keep it consistent with how you mount it at corner 1. This will take some practice to get used to. Now calibrated corner 3
6) Move the bed in Y direction to calibrate corner 4.
7) Remove the indicator and home the extruder. Check again with a piece of paper to be sure.
Figure:
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
