MP Mini Enclosure

This is a 2 panel version of an enclosure for a Monoprice mini delta printer.

I printed this on an ender 3 with supports at 20% infill.

Needed:

- 3 Prints of each file

- 3 Pieces of glass ( I bought a big picture frame at Walmart for 10$ and a glass cutter at harbor freight for 15$ and cut 3 pieces to size, with extra glass for spares to be sure i had enough.)

- 2 paper clips or some kind of rod to use for the hinge so the doors can swing open ( I had some servo rods for an rc car laying around so i took that and bent the top a little at a 90 degree angle and slide that down the hinges for the door.

After the print is done for the outer panels holding the glass be careful removing it from the bed and the supports as the clip that is used to hold the panel shut is 3d printed in the air in the file, yes it works printing like this with supports I have successfully done many already.

I used some JB weld plastic bonding to hold the glass into place once i painted