Thingiverse
MP Mini Select printer foot
por lukemillermakes
15
Descargas
4
Likes
0
Makes
I lost the rubber feet one one side of my printer. This meant that it was scratching the surface underneath and there wasn't any airflow underneath.
These little feet allow you to take off 4 of the screws on the bottom plate, put them through the feet, and screw them back. It raises the printer a bit so there is increased airflow.
These little feet allow you to take off 4 of the screws on the bottom plate, put them through the feet, and screw them back. It raises the printer a bit so there is increased airflow.
lukemillermakes también publica en
5 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
