MP Select Mini Beefy Bed Wire Harness

This is a beefy heat bed wire harness for the Monoprice Select Mini 3D Printer.

This part is intended to be used as a apart of the common heat bed wire modification that is often required to prevent damage of the heat bed wires during Y axis movement.

The part has an integrated zip tie holder that can be used to secure the heat bed wires to the harness to prevent stress on the heat bed solder joints during movement

WARNING: Use caution with the zip tie as if it is too large, it may interfere with the lowest Z-Axis level. Place you zip tie on, tighten it, pull the bed completely forward, and lower the z axis completely. Make sure the zip tie head does not interfere with the gantry. If it does, use a smaller zip tie.

I used M3 screws and nuts to secure the wire harness to the bed.