Thingiverse
MP Select Mini carrying handle
von ibraud
44
Downloads
24
Likes
0
Makes
I printed mine upside down with support, and it seems sturdy enough at 25% infill. Bolts to the top of the tower.
There are two versions - the normal handle and a "pimount" version that's compatible with the VESA mounting bracket:
http://www.thingiverse.com/thing:1718715
I needed longer M3 screws for the rear to bolt together with the VESA mount plus the handle, luckily I have tons of them. The normal version should bolt on using the stock screws.
Also check out this remix, it's probably much sturdier than mine!
http://www.thingiverse.com/thing:1790201
There are two versions - the normal handle and a "pimount" version that's compatible with the VESA mounting bracket:
http://www.thingiverse.com/thing:1718715
I needed longer M3 screws for the rear to bolt together with the VESA mount plus the handle, luckily I have tons of them. The normal version should bolt on using the stock screws.
Also check out this remix, it's probably much sturdier than mine!
http://www.thingiverse.com/thing:1790201
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
