Thingiverse
MP07-IONA-US Case
di Zepherino
3
Download
7
Likes
0
Makes
WARNING: Installation needs a bit of force to flex the case and fit the PCB. I take no responsibility if you damage your PCB.
This is a snap fit case for Mellow PCB's MP07-IONA-US JVS/USB I/O board.
The tolerances are somewhat tight, and PETG is highly recommended over PLA for this model. PETG has better layer adhesion, which needed for the snap tabs. PETG also not as stiff as PLA, which will be needed to flex the case and fit the PCB inside. The MicroUSB side of the case will need to flex slightly as you push the PCB into the case in order to fit the port. Be careful when you do this, as the MicroUSB port is somewhat fragile.
For a tighter fit, you can cut some electrical tape and stick it on the stand that sits above the 2 USB-A ports located on the lid of the case. 3-4 layers made the fit nice and snug for me. See provided photos for an example.
This is a snap fit case for Mellow PCB's MP07-IONA-US JVS/USB I/O board.
The tolerances are somewhat tight, and PETG is highly recommended over PLA for this model. PETG has better layer adhesion, which needed for the snap tabs. PETG also not as stiff as PLA, which will be needed to flex the case and fit the PCB inside. The MicroUSB side of the case will need to flex slightly as you push the PCB into the case in order to fit the port. Be careful when you do this, as the MicroUSB port is somewhat fragile.
For a tighter fit, you can cut some electrical tape and stick it on the stand that sits above the 2 USB-A ports located on the lid of the case. 3-4 layers made the fit nice and snug for me. See provided photos for an example.
Zepherino pubblica anche su
8 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
