Thingiverse
MP5 BESSL
von worracle
12
Downloads
8
Likes
0
Makes
UPDATE: September 1 2020
NEW DESIGN.
ESSL System For Binary + Pictogram housing.
Print upside down on the flat edge (there is a reason there is a flat edge) with NO support. Slow, Low layer height. High resolution. This is going on a HK, not a garbage can.
I Print them in Nylon-G. 260c. 30mm/s
Also, use my binary shims for best fit! - https://www.thingiverse.com/thing:4005203
NEW DESIGN.
ESSL System For Binary + Pictogram housing.
Print upside down on the flat edge (there is a reason there is a flat edge) with NO support. Slow, Low layer height. High resolution. This is going on a HK, not a garbage can.
I Print them in Nylon-G. 260c. 30mm/s
Also, use my binary shims for best fit! - https://www.thingiverse.com/thing:4005203
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!