Thingiverse
MPC Live Stand v1.5
door autotechmusic
33
Downloads
30
Likes
1
Makes
MPC Live Stand v1.5
Design with a comfortable viewing angle of about 125 degrees. Mostly for working with the screen for long periods of time. You can always lay the MPC flat on a surface for beating on the pads. However, I have no trouble recording drum patterns.
I recommend putting rubber feet on the bottom to prevent slipping, as PLA is quite smooth (I installed foam pads to the bottom if mine). I also installed small foam pads to all sides that touch the MPC to prevent sliding as well. After those slight mods, you can smash away.
The braces are pressure fitted, but I still recommend gluing or epoxying for good measure, as the MPC Live is a bit heavy.
Print:
2 x Stands
2 x Braces
No need to mirror, just print each twice.
Design with a comfortable viewing angle of about 125 degrees. Mostly for working with the screen for long periods of time. You can always lay the MPC flat on a surface for beating on the pads. However, I have no trouble recording drum patterns.
I recommend putting rubber feet on the bottom to prevent slipping, as PLA is quite smooth (I installed foam pads to the bottom if mine). I also installed small foam pads to all sides that touch the MPC to prevent sliding as well. After those slight mods, you can smash away.
The braces are pressure fitted, but I still recommend gluing or epoxying for good measure, as the MPC Live is a bit heavy.
Print:
2 x Stands
2 x Braces
No need to mirror, just print each twice.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!