Thingiverse
MPCNC 25mm Rail Support
door raphael303
3
Downloads
0
Likes
0
Makes
I didn't like the other supports available here. This one is slim and works. Just add an 8mm threaded bar with two nuts.
The bar should be 1cm less than the distance of the rail to the table.
The Fusion360 file is attached here too.
The bar should be 1cm less than the distance of the rail to the table.
The Fusion360 file is attached here too.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
