MakerWorld
Electronics
MPCNC CASE
by lindh3d
24
Downloads
16
Likes
7
Makes
A nice looking controller box for the RAMBo 1.4 and the RepRapDiscount Full Graphics Smart Controller. This setup is for an MPCNC but can easily be used for other machines as well.I recommend that you set the fan to blow from inside out and mount a filter inside in the front to prevent dust to enter the control board.The fan needs to be 12V and connected to PIN 2 on the board. I haven't fully tested this myself yet but after adding the fan you need to change the code as one of the picture shows
Sign in to leave a comment
Sign in