Thingiverse
MPCNC Drill Helper Z-Axis
por OfSalty
1
Descargas
0
Likes
0
Makes
Hey Everyone,
i created this Helper to be able to drill the holes in the Z-Axis. Its for the 25mm Tubes. It has 2 Sides. On one side it has 2mm holes for pre dilling on the other side you can use a 6mm drill.
I also put a Part which is smaller as a support
i created this Helper to be able to drill the holes in the Z-Axis. Its for the 25mm Tubes. It has 2 Sides. On one side it has 2mm holes for pre dilling on the other side you can use a 6mm drill.
I also put a Part which is smaller as a support
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!