Thingiverse
MPCNC Elongated Endstop Block
door Binary_Bandit
4
Downloads
6
Likes
0
Makes
Apologies for the formatting. Thingiverse seems to be having an issue with the markdown in the text...
I began building my MPCNC machine and found that it was difficult to get the end stops mounted using the [Clean Dual Endstop Mount](https://www.thingiverse.com/thing:2847042)
After looking into it a bit and realizing I had to bend the pins, I looked for an [alternative](https://forum.v1engineering.com/t/dual-stop-holders/17695?u=binary_bandit)
I came across user [thingsdavemade's model](https://www.thingiverse.com/thing:3822377) for the conduit mounted block but it still required that the endstop was mounted on the inside of the mounting plate.
I elongated the stop block so that I can have it on the outside.
This is very similar to user [blindmoe's remix](https://www.thingiverse.com/thing:3847478) but I made it for the 23.5 size of conduit. (as I am in the US)
__This is for the 23.5 Conduit__
I began building my MPCNC machine and found that it was difficult to get the end stops mounted using the [Clean Dual Endstop Mount](https://www.thingiverse.com/thing:2847042)
After looking into it a bit and realizing I had to bend the pins, I looked for an [alternative](https://forum.v1engineering.com/t/dual-stop-holders/17695?u=binary_bandit)
I came across user [thingsdavemade's model](https://www.thingiverse.com/thing:3822377) for the conduit mounted block but it still required that the endstop was mounted on the inside of the mounting plate.
I elongated the stop block so that I can have it on the outside.
This is very similar to user [blindmoe's remix](https://www.thingiverse.com/thing:3847478) but I made it for the 23.5 size of conduit. (as I am in the US)
__This is for the 23.5 Conduit__
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!