MPCNC end stop block

End stop block replacement for the small block that fits on the belt. This one attaches to the conduit so it stays stationary when adjusting the belts.

I had got everything squared up with the original blocks, then decided to tighten the belts only to realize that everything was out of square again. By attaching the end stops to the conduit they will stay static in reference to the machine and table.

All the other solutions I found required the end stop switches to be moved to the conduits but I'd already wired everything up so this was a better solutions.

Seem rock solid printed in PLA - they are a very tight fit over the conduit though, attaches using 20mm M4 bolts (the same as used elsewhere in the build) - not tested with the imperial equivalent but don't think that should be an issue.

I've only used the 25mm version, so the other two are untested, mention in the comments if there's any issues.