MPCNC gantry squaring aid

MPCNC gantry squaring aid
======================

These parts should help squaring the middle assembly aka gantry of the MPCNC.

3D view: https://a360.co/2FIYKO1

**Things you need additionally:**

- 2x 130mm M6 threaded rod
- 2x 160mm M6 threaded rod
optional: 2x 150mm threaded rod for the third hole, but it might not fit through because of the position of your lock nuts or screw hats inside the XY part - you got to try on your own and see, if you really need it
- some M6 lock nuts
- optional: 2x butterfly nuts

Look at the pictures on how it is assembled, it is not too complicated.

**XY parts - increase outside angle**

The pictures show my setup. The outer angle between both XY parts (black) was a bit smaller than 270 degrees, that's why the butterfly nut is there on the inside to press the parts apart from each other => this increases the outside angle.

**XY parts - decrease outside angle**

If you need to make the angle smaller, you can simply put the butt