Thingiverse
MPCNC Laser Driver Enclosure
von rvaughan655
6
Downloads
3
Likes
0
Makes
This Box is for my 2.8 watt Laser upgrade for the mpcnc.
It uses 8-32 hardware to hold everything together.
Here is the link to the instructions I used.
https://www.v1engineering.com/wp-content/uploads/2016/01/MPCNC-laser-add-on-walk-through-Rev2.0.pdf
It uses 8-32 hardware to hold everything together.
Here is the link to the instructions I used.
https://www.v1engineering.com/wp-content/uploads/2016/01/MPCNC-laser-add-on-walk-through-Rev2.0.pdf
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
