MPCNC LCD Enclosure

Reprap LCD Enclosure, intended for an MPCNC or similar application, includes:

- LCD Enclosure Faceplate - print face side down
- LCD Enclosure Back (minor support for SD opening and bolt recess)
- Stop Button
- Dimmer hole Plug (optional)
- Mounting Plate
- Legs for Mounting Plate (basic, can be modified)
- Dovetails are 120 degrees, 10mm at thin end by 7.5mm deep, undersize yours by .5mm for a very tight fit)
- M3 washer / spacers

Hardware recommended:

- M3 x 8mm for LCD mounting - might need to clean up / drill / tap depending on your print tolerance
- M4 x 30mm for Enclosure (recommend hex type) and running a drill bit through the back of the enclosure to make it a bit easier and tapping the faceplate.
- 32mm (1.26 inch) round magnet, or any magnet that fits in the recess. You can add multiple magnets for additional holding force.

OnShape design files are available in below link:

https://cad.onshape.com/documents/5d1fd9060e0e2ed768f3cd42/w/d6e708bdd10a