MPCNC-Noorlandt.Design Version

I build a bigger MPCNC and wasn't very happy with the strength of the legs. So I welded a steel frame from 50x50x1.6mm RHS. The printed corner blocks slide over the RHS and are adjustable in the X Y and Z direction to make up for the welding warp.

This was based on an MPCNC V1 but I made plenty of holes in the blocks to allow for belt tensioners of the V2. I had both models in the design when designing.

I used a 16core and a 24core travel cable, leftover from the lifting industry.
This is not a must, you can use any cabling system you want.