Thingiverse
MPCNC Primo Cable Run Mounts
door niget2002
130
Downloads
58
Likes
0
Makes
The new MPCNC Primo was recently released and there's not a lot of parts for it for add ons. This is my take of a mount for a cable run for the spindle and Z stepper motor.
It's designed for the 25.4mm (1") tubing and 27mm angle aluminum. I just use zip ties to hold it on, but you could drill a hole through the top part and use a bolt.
I used 4mm x16mm cap bolts to mount it to the rail. The clamp should be faced so that the angle is towards the trucks. That way you can push it closer to the truck for more clearance.
The angle aluminum should just clear the edge of the core part of the machine and have a few mm clearance above the top rail.
It's designed for the 25.4mm (1") tubing and 27mm angle aluminum. I just use zip ties to hold it on, but you could drill a hole through the top part and use a bolt.
I used 4mm x16mm cap bolts to mount it to the rail. The clamp should be faced so that the angle is towards the trucks. That way you can push it closer to the truck for more clearance.
The angle aluminum should just clear the edge of the core part of the machine and have a few mm clearance above the top rail.
niget2002 publiceert ook op
30 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!