MPCNC with Makerbase MKS TFT28

This color touch display works out of the box without any firmware modifications for the MPCNC. You just need to connect to AUX 1 on the RAMPS 1.4 board, set the voltage jumper on the on the TFT board at the 5V position and voila.
The display is made by MakerBase and the design is open-source kept at Github with all details here:
https://github.com/makerbase-mks/MKS-TFT
Thanks Dindit for the faceplate remix based on pma's design and all the great info about the hardware.

- Remixed MPCNC Corner Block Lock to add a M5 threaded rod for the articulated support.
- Remixed mount plate to add articulated support.

I printed with .320 layer height in PETG to print fast, but any settings/filament should work fine. For the Corner Block Lock you should use high infill. Please note Alted's MPCNC infill recommendation for the Corner Block Lock is 70%.

Parts:
- MKS TFT28 Display
- M5 Threaded Rod - around 20 cm. If you want to position the display higher you will need to replace