Thingiverse
MPLAB Snap Debugger enclosure
von grwori
0
Downloads
2
Likes
0
Makes
I add a ventilation opening because the Snap getting hot. A bar between the LEDs for better contrast, an arrow for pin 1 and a small cut off for opening with a screw driver.
top2.stl is for the new revision of the Snap with Jumper AVR/PIC
top2.stl is for the new revision of the Snap with Jumper AVR/PIC
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!