MPMD Covid19 Face Shield

Updates
20/04/2020 (2)
Just uploaded an improved version of the zip tie model.
FS 4 X
2 x Arm
1 x Centre (OP)
2 x Side (OP)
or
2 x Arm
1 x Centre (CL)
1 x Left Side (CL)
1 x Right Side (CL)

This one has slightly stronger pegs to hold the plastic and a better arm for holding the back elastic. The alignment peg holes are slightly tapered to allow for an easier fit. Depending on your calibration you may have to trim these to fit.
This model can be printed in one build if the sides are stacked. Print time for the open style is under 1 hour 30 minutes.
Note: these parts print to the edges of the build plate. You may need to ensure you have good adhesion as the parts may come loose at the ends and then rock themselves free.

20/04/2020
Note: I have removed these files as the FS 4 X version is basically the same but improved. I left the images which show the zip tie connections for reference

I have uploaded a different style that does not include a hinge. It is compri