MPMD Dual Fan Custom Effector

**Warning** (28/11/19)
The Transparent PLA I used to print the model was too soft at higher printing temps. I ran a few prints that had the nozzle temp around 135 degrees and this softened the front of the effector enough that it began to distort. This is the thinnest part of the structural portion. Eventually the framework distorted by forcing the front of the effector to bend downwards. As a result the effector no longer sits perpendicular to the bed and will result in the effector tilting quite a bit. I will have to try and print a version out of a higher temperature filament to see if this solves the problem.
This effect is not obvious at first. It does not happen during a single print but over several so you may not notice the distortion immediately.

**Note: (21/11/19)**
Thingiverse took so long to display the files that I didn't notice I had the wrong collar. I believe the proper file is now uploaded. Let me know if you find that it is not correct.
I have also removed the