MPMD feet

To overcome what may be some overheating issues with my Monoprice Mini Delta, I designed some feet that can be placed in each corner and not get in the way of removing the bottom plate. The picture is of the foot that will lift up the printer 1.5cm. Keep in mind the original feet are about .4cm tall so this will add about 1.1cm of lift. Since there is nothing holding these in place, you may want to use some double sided tape to get them to stay in place.

Another thing to note is that this is printed on my uncalibrated Mini Delta, which has been printing about 2% smaller than the given dimensions. Print one to see if it fits in the notch and if it doesn't fit, try scaling down to 98%.