MPMD Magnetic draft covers

I had seen a snap on tool holder for the MPMD (MPMD Side Clip
by PorchPhysics Dec 9, 2017) and thought I would use the same concept to create a snap-on holder for my 10A PS. It worked quite well, so when we had a cold snap and I began to have adhesion problems, which I attributed to a drafty area where my printer was located, I decided to use the same idea to create a magnet enclosure for my MPMD.
The clips are magnetic so they can be used to hold a variety of things other than the covers. The covers themselves are just made out of cardboard and are attached to the clips with a magnetic hanger/stand. Other materials could be used instead of cardboad, I just happened to have a few pieces of cardboard which happened to be a size that worked.
The only caution is, that when you glue in the magnets, you have to make sure that the polarity of the magnets is set correctly.
The snap on clips have spaces for 3-12mm neodymium magnets and the magnetic card holder has a space for one.
You c